Dynojet Target Tune - Reading the ECU-Power Vision 3; C3 Software-Enable Target Tune

11
Use the following instructions to use the tune currently
fl ashed to your ECU. This process takes about fi fteen minutes.
1 Connect the Power Vision 3 to the vehicle diagnostic port.
2 Turn the key on.
3 Select Vehicle Tools>Read ECU. This process takes a few
minutes.
3 Remove the Power Vision 3 from the bike and connect the
Power Vision 3 to your computer using the included USB cable.
The Power Vision 3 will automatically enter USB Mode.
4 Transfer the stock tune from the Power Vision 3 to your
computer.
5 Email the tune to pv3hdtech@dynojet.com.
READ ECU
AN ECU READ CAN TAKE UP TO
3 MINUTES TO COMPLETE
PRESS TO RETURN
PRESS TO CONTINUE
READING THE ECU–POWER VISION 3
Skip the wait and apply the Target Tune values right in
C3 Tuning Software using Enable Target Tune.
1 Open C3 Tuning Software.
2 From the Home ribbon, click Open.
3 Browse to your .stk fi le.
4 Select the fi le and click Open.
5 Click Enable Target Tune.
Note: This feature is not available for all Harley-Davidson
software levels.
6 If you are using the Power Vision 3, save your new fi le as a .djt.
If you are using the Power Vision, click Export as PVT.
7 Save this new fi le to your device.
8 Flash the new fi le to your bike.
C3 SOFTWARE–ENABLE TARGET TUNE
C3 SOFTWARE–ENABLE TARGET TUNE