330-411 www.powercommander.com 06-08 Suzuki M109R - 4
13 Plug the Dynojet O2 eliminator into the
stock wiring harness.
14 Route the O2 eliminator harness to the
inside of the frame near the thermostat
housing (Fig. G).
FIG G
15 Ground the other end of the Dynojet O2
eliminator to the bolt of the thermostat
housing (Fig. H).
FIG H
O2 eliminator
Ground
FIG J
16 Secure the PCIII in the tail section using
the supplied velcro. Make sure to use the
alcohol swab to clean both surfaces before
attaching.
17 Bolt the fuel tank back into place. Reinstall
the fairing and seats.
To Previous Page
Loading...
