IFC22035 www.powercommander.com 2009-2017Yamaha XV950, Bolt 950, & SCR950 - 3
1 Remove the seat.
2 Remove the fuel tank.
3 Remove both side covers beneath the seat.
4 Loosen the ECM strap and lift the ECM out of place to access the battery.
5 Attach the ground wire from the PCFC to the negative side of the battery.
6 Reinstall the ECM back into place.
7 Using the supplied velcro, secure the PCFC to the top of the ECM.
Make sure to clean both surfaces with the alcohol swab before attaching.
Note: You can also secure the PCFC module under the stock ECM strap.
8 Route the PCFC harness forward going under the frame tubes directly under
the seat, then upward along the backbone of the frame towards the engine.
FIG.A
FIG.B
FIG.C
ground
To Next Page
Loading...
