IFC22035 www.powercommander.com 2009-2017Yamaha XV950, Bolt 950, & SCR950 - 5
13 Attach the connectors from the PCFC to the TPS and stock wiring harness.
14 Unplug the stock O2 sensor connections.
The O2 sensor connector is located just in front of the pivot shaft of the swing
arm on the right side of the bike. You can trace the wires from the stock O2
sensor (in the exhaust) to this connector.
15 Attach the connectors from the PCFC to the stock O2 sensor and wiring
harness.
To utilize the O2 control feature of the PCFC, the stock O2 sensor must
remain in the exhaust and active.
16 Replace the side covers.
17 Replace the fuel tank.
18 Replace the seat.
FIG.G
FIG.H
FIG.I
To Next Page
Loading...
