IFC16901 www.powercommander.com 2007-2014 Honda SH300i - 3
1 Lift up the seat.
2 Remove the eight bolts as shown in Figure A.
3 Remove the plastic trunk to access the engine.
4 Remove the battery access panel.
5 Using the supplied velcro, secure the PCFC next to the opening in the battery.
Make sure to clean both surfaces with the alcohol swab before attaching.
6 Attach the ground wire from the PCFC to the negative side of the battery as
shown in Figure B.
7 Unplug the stock wiring harness from the fuel injector as shown in Figure C.
Ground
FIG.A
FIG.B
FIG.C
Unplug
To Next Page
Loading...
