Dynojet Power commander V - Wiring Connections to Fuel System; PCV to Injector Wiring; PCV to Throttle Position Sensor

16-044 www.powercommander.com 2009-2013 Honda Goldwing/FB6 - PCV - 5
11 Route the PCV harness branch with the pair of BLACK 10-pin connectors
through the location shown in Figure G. This area is underneath the left air
scoop that was removed in Step. 9.
You can follow along side the cable for the vents.
FIG. G
12 At the front of the bike, locate and unplug the stock connector for the left fuel
injector bank (Fig. H).
This is a BLACK 10-pin connector just inside of the frame on the left side. It is
difficult to access.
FIG.H
13 Plug the matching pair of connectors of the PCV harness in-line with the stock
connectors (Fig. J).
FIG.J
Unplug