25-004 www.powercommander.com 09-11 CanAm Spyder PCV - 3
1 Remove the cosmetic covers on both the right and left sides (Fig. A).
2 Remove the air box cover by releasing the clips around the edge of the air box
(Fig. B).
3 To remove the air box base, remove the 6 bolts around the velocity stacks
(Fig. C).
Only 4 bolts are visible in Figure C.
4 Cut the 3 zip ties on the left side of the air box that secure the wiring harness.
5 Pull the air box base out the right side. This allows access to the injector
connectors.
FIG.A
FIG.C
Remove
Ground wire
FIG.B
To Next Page
Loading...
