Dynon Avionics SkyView SE - Page 82

Messages and Alerts
9-6 SkyView SE Pilot’s User Guide - Revision B
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Warning”
ADAHRS CAL
CORRUPT
Contact Dynon for assistance
“Warning”
DEMO MODE
System is in Dynon demo mode
and is not airworthy
“Warning”
PITCH SERVO
OFFLINE
The Pitch Autopilot servo has
stopped communicating with
SkyView SE. Will be seen if
Autopilot servos are not receiving
power.
“Warning”
ROLL SERVO
OFFLINE
The Roll Autopilot servo has
stopped communicating with
SkyView SE. Will be seen if
Autopilot servos are not receiving
power.
“Warning”
BACKUP BATTERY
LOW
The backup battery connected to
this display is low.
“Warning”
SKYNET POWER
FAULT
A fault has been detected in the
wires that provide power to
SkyView SE Network devices.
“Warning”
AUDIO SUBSYSTEM
FAIL
SkyView SE has detected a
problem with the audio system.
“Check Canopy Latch”
CHECK CANOPY
LATCH
A canopy latch alert is configured;
The canopy is not latched; and the
engine has been advanced past a
configured RPM.
“Warning”
MAG FACT CAL
CORRUPT
Contact Dynon Avionics for
assistance
“Caution”
STANDBY NETWORK
ERROR
SkyView SE Network has lost its
secondary standby network
redundancy. See below for more
information.
“Caution”
POSITION SOURCE
or GPS X FAIL
Position source (GPS) failure
“Caution”
TRANSPONDER FAIL
Transponder failure.
“Caution”
XPNDR HEX CODE
NOT SET
A SkyView SE Transponder or
ADS-B receiver is installed but the
HEX Code has not been set.