Dynon Avionics SkyView SE - Page 83

Messages and Alerts
SkyView SE Pilot’s User Guide - Revision B 9-7
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Caution”
EMS SFG FILE
MISMATCH
The Engine sensor indications may
be incorrect and screens may
disagree.
“Caution”
NO ADSB OUT: GPS
LOST
The GPS source that provides GPS
position to the SV-XPNDR-261 for
ADS-B Out use is offline.
“Caution”
BACKUP BATTERY IN
USE
System has switched to SkyView
SE Backup Battery.
“Caution”
OTHER DISPLAY
OFFLINE
A SkyView SE Display has failed or
is no longer communicating via
SkyView Network.
“Caution”
NEED COMPASS CAL
Magnetic compass heading in
either the SV-ADAHRS-200/201 or
SV-MAG-236 is not calibrated.
“Caution”
COMPASS FAIL
The SkyView SE Remote
Magnetometer has failed or is no
longer communicating via
SkyView Network.
“Caution”
NEED USER AOA
CAL
AOA is not properly calibrated
“Caution”
GPS ASSIST
Airspeed information is not
available; GPS is being used to aid
in the computation of attitude
information; Attitude may be
degraded
“Caution”
ADAHRS CAL OLD
Contact Dynon Avionics for
assistance
“Caution”
AP BROKEN
DISCONNECT
Autopilot disconnect switch wire
is broken
“Caution”
AP DISCONNECT
STUCK
Autopilot disconnect switch wire
is stuck
“Caution”
XPNDR ALT
ENCODER FAIL
Altitude is not being sent to the
SV-XPNDR-261/262 because it is
not available from its nominal
barometric altitude source.
“Caution”
ACTV ADAHRS
VIBRATION
The currently-active ADAHRS has
detected vibration that will affect
G Meter and Autopilot, attitude
indicator performance.
Troubleshoot when able.