Dyson purifier cool Gen1 User Manual

Changing your HEPA+Carbon filter
Supplied with a HEPA+Carbon filter.
To change your HEPA+Carbon filter, push down on the buttons either side
of your machine to release the outer cover. Push down on the tabs to remove
the filter.
Push the replacement filter into the outer cover and make sure the tabs click
into place.
Put the outer covers into position on your machine and push firmly until they
both click securely into position.
Plug in and switch your machine, and reset your filter life.
Resetting your HEPA+Carbon filter life
Resetting your HEPA+Carbon filter life
It's important to reset your filter life after you have replaced your filter.
Press and hold the Night mode button on your remote control.
The display on your machine will countdown from five, the filter life will
be reset and your machine is ready to use.
Before changing your filter, switch off and unplug your Dyson purifying fan.
The remaining filter life is displayed on the screen and will indicate when
your non-washable filters need replacing. Press the Information button
on your remote.
You’ll need to reset the filter life on your machine.
Dyson Purifier Cool Gen1
5
sec
The air purifier fan with the filter covers open
showing a HEPA plus carbon filter located in the
filter covers. Arrows demonstrate that the filter
covers will need to be assembled onto the base
of the machine.
Pressing the Night mode
and Sleep timer button
on the middle right of the
remote control, above the
Information menu button
for 5 seconds.

Dyson purifier cool Gen1 Specifications

General

Airflow	290 l/s
Air speed	1.2 m/s
Cord length	1.8 m
Sleep timer	Yes
Air purify rate	- m³/h
Number of speeds	10
Oscillation angle	350 °
Air purifiers functions	Fan, Heating
Noise level (low speed)	42.6 dB
Noise level (high speed)	61.4 dB
Timer duration (maximum)	8 h
Timer duration (minimum)	1 h
Suitable for room area up to	27 m²
Package depth	260 mm
Package width	257 mm
Package height	1103 mm
Package weight	6850 g
Battery type	CR2032L
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Power consumption (max)	- W
Power consumption (standby)	1 W
Fine particle (PM2.5) numeric reading range	12 µg/m³
HEPA class	HEPA 13
Filter life (max)	12 month(s)
Display type	LED
Product color	White

Weight and Dimensions

Depth	120 mm
Width	204 mm
Height	1050 mm
Weight	4730 g
Remote control weight	25 g
Remote control dimensions (W x H x D)	32.2 x 10.49 x 90 mm