Wash the foam element of the filter unit next; hold the filter unit under a cold water tap with the foam element
downwards so that dirty water does not contaminate the pleated paper element. Run cold water over the inside and
outside of the foam element and squeeze the foam gently to expel the dirt. Repeat washing both parts of the filter unit
until the water runs clear. Gently shake the filter unit to remove any excess water and leave to drain with the foam
element end facing up. Leave the filter unit to dry completely in a dry environment with good airflow, for a minimum of
24 hours.
Check that the filter unit is completely dry. To refit, position the filter unit in place on the main body and twist
clockwise until it clicks into place.
The filter unit may require more frequent washing if vacuuming fine dust or if used mostly in Boost mode. Don’t put
any part of your machine in a dishwasher, washing machine, tumble dryer, oven, microwave or near a naked flame.
Washing your High Torque XL cleaner head
To maintain optimum performance, check and wash your brush bar regularly.
Make sure your machine is disconnected from the charger and take care not to touch the trigger.
To Next Page
Loading...
Need help?
General
