Turn the transmitter on first and lower the throttle stick and trim completely. Then, plug the battery into the battery
lead of the 2-in-1 unit.
Control Test
Although each Blade CP Pro 2 model is test flown at the factory, it is a good idea to test the controls prior to the
first flight to ensure none of the servos, linkages or parts were damaged during shipping and handling. Before
proceeding, unplug both the main and tail motors from the 2-in-1 control unit. It is not safe to perform the control
test with the main or tail motor plugs connected to the 2-in-1 control unit after power up.
Mode 2 Mode 1
To Next Page
Loading...
