E-XTEQ DCBS - Wi-Fi Connection (Remote to Trolley)

13/52
DCBS User Manual / Ref. MAN_DCBS_GM_EN_V1.0
Initial Setup 4/8
WI-FI CONNECTION (REMOTE TO TROLLEY ONLY) ////////
This setting is to connect the Remote to the Trolley via Wi-Fi only. Physical
connection via Ethernet cable will not work if the Wi-Fi setting is used. If
the wireless connection between the Remote and Trolley is not stable due
to Electromagnetic Interference, please use physical connection option
explained below.
1. Turn on the Remote and go to the
“Settings” icon.
2. Go to the “Wireless” icon.
3. Select “Trolley connection” Icon
5. Select “Bar-code Scan” for the
tool to scan the trolley serial number
or “Manual” to manually input the
trolley serial number.
6. The Serial Number can be found
on the back of the trolley. Refer to
picture for visual conrmation.
4.Select your preferred Wi-Fi
Frequency. (If this option is not available,
continue to step 5)
Table of Content
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Getting Started
Safety Reminders
Appearance and Dimensions
Trolley LED’s
Remote Presentation
Remote Job Storage
Accessories
Initial Setup
Installation
Battery Cable Clamps Connection
Power Cable Connection and Power On
Dealer Id. N°
Wi-Fi Connection (Remote to Trolley)
Physical Connection (Remote to Trolley)
Update
Settings
Preferences
Other Settings
Diagnostic and Charge
Remote handheld diagnostic tester
-Manual Selection of Battery
-Vehicle Selection from Database
-Start Diagnostic & Results
Trolley Diagnostic
-Complete Diagnostic & Results
-Pre Delivery Inspection Test (PDI) & Results
-Charge & Results
-Load Test & Results
-Enhanced Diagnostic Mode (EDM) & Results
-Reserve Capacity Test & Results
History (Results Storage)
Optimus
-Optimus Installation
-Using Optimus
Support Information
-Batteries
-Error Messages
Warranty