E-XTEQ DCBS - Pre Delivery Inspection Test (PDI) & Results

28/52
DCBS User Manual / Ref. MAN_DCBS_GM_EN_V1.0
Diagnostic and Charge 9/24
PRE-DELIVERY INSPECTION ////////
PDI (Pre-Delivery Inspection)
DCBS Trolley has an option for the dealership to use during a PDI. PDI Icon
will follow GM specications for Pre-Delivery Inspection. (No Warranty
code will be generated during PDI.)
PDI will perform a 20 minute charge on the battery.
Follow the steps in Manual Battery Selection or Database Selection to select
the battery information. (See section “Manual Battery Selection” and Vehicle
Selection from Database” listed above).
If the remote is not connected to the trolley via Wi-Fi, connection will be
attempted automatically. If Physical Connection option is selected, RJ45
cable must be connected to Remote and Trolley at the start of the test.
Table of Content
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Getting Started
Safety Reminders
Appearance and Dimensions
Trolley LED’s
Remote Presentation
Remote Job Storage
Accessories
Initial Setup
Installation
Battery Cable Clamps Connection
Power Cable Connection and Power On
Dealer Id. N°
Wi-Fi Connection (Remote to Trolley)
Physical Connection (Remote to Trolley)
Update
Settings
Preferences
Other Settings
Diagnostic and Charge
Remote handheld diagnostic tester
-Manual Selection of Battery
-Vehicle Selection from Database
-Start Diagnostic & Results
Trolley Diagnostic
-Complete Diagnostic & Results
-Pre Delivery Inspection Test (PDI) & Results
-Charge & Results
-Load Test & Results
-Enhanced Diagnostic Mode (EDM) & Results
-Reserve Capacity Test & Results
History (Results Storage)
Optimus
-Optimus Installation
-Using Optimus
Support Information
-Batteries
-Error Messages
Warranty