31/52
DCBS User Manual / Ref. MAN_DCBS_GM_EN_V1.0
Diagnostic and Charge 12/24
CHARGE ////////
Charge
“Charge” Icon will be used to charge the 12V batteries. Charge acceptance
allows to diagnose if and how the battery can accept the charge (100A
range). During the dynamic charge, and depending on the battery reaction
during the charge, intermediate tests can detect different issues with the
battery (Sulfation, etc.).
In the “Charge” Icon, the user has the option to select between “Normal
Charge mode” (40A) and “Fast Charge Mode” (80A/100A).
Follow the steps in Manual Battery Selection or Database Selection to select
the battery information. (See section “Manual Battery Selection” and Vehicle
Selection from Database” listed above).
Table of Content
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Getting Started
Safety Reminders
Appearance and Dimensions
Trolley LED’s
Remote Presentation
Remote Job Storage
Accessories
Initial Setup
Installation
Battery Cable Clamps Connection
Power Cable Connection and Power On
Dealer Id. N°
Wi-Fi Connection (Remote to Trolley)
Physical Connection (Remote to Trolley)
Update
Settings
Preferences
Other Settings
Diagnostic and Charge
Remote handheld diagnostic tester
-Manual Selection of Battery
-Vehicle Selection from Database
-Start Diagnostic & Results
Trolley Diagnostic
-Complete Diagnostic & Results
-Pre Delivery Inspection Test (PDI) & Results
-Charge & Results
-Load Test & Results
-Enhanced Diagnostic Mode (EDM) & Results
-Reserve Capacity Test & Results
History (Results Storage)
Optimus
-Optimus Installation
-Using Optimus
Support Information
-Batteries
-Error Messages
Warranty
To Next Page
Loading...
