E-XTEQ DCBS - Page 33

33/52
DCBS User Manual / Ref. MAN_DCBS_GM_EN_V1.0
Diagnostic and Charge 14/24
CHARGE ////////
If the charge nishes with no
issues, the tool will show “Battery is
Charged”.
After 24 hours of charge (or<0.2A)
with no issues, the Charge result
will come back as “Battery is fully
Charged”.
If the clamps are not detecting the
battery correctly, the result will
come back as “Clamp Connection
Failure” and the test must be
performed again.
After pressing the Button, the
results will display showing the
charge result as “Battery is Bad”
Results - (Charge)
If an issue is found with the battery,
the tool will show a battery with an
X through it.
If an issue is found with the battery,
the result will display showing the
charge result as “Not Done”.
Table of Content
Introduction
Safety Guidelines
Maintenance and Storage
Before Use
Usage Precautions
Disassembly/Damage/Removal
Cleaning the Product
Getting Started
Safety Reminders
Appearance and Dimensions
Trolley LED’s
Remote Presentation
Remote Job Storage
Accessories
Initial Setup
Installation
Battery Cable Clamps Connection
Power Cable Connection and Power On
Dealer Id. N°
Wi-Fi Connection (Remote to Trolley)
Physical Connection (Remote to Trolley)
Update
Settings
Preferences
Other Settings
Diagnostic and Charge
Remote handheld diagnostic tester
-Manual Selection of Battery
-Vehicle Selection from Database
-Start Diagnostic & Results
Trolley Diagnostic
-Complete Diagnostic & Results
-Pre Delivery Inspection Test (PDI) & Results
-Charge & Results
-Load Test & Results
-Enhanced Diagnostic Mode (EDM) & Results
-Reserve Capacity Test & Results
History (Results Storage)
Optimus
-Optimus Installation
-Using Optimus
Support Information
-Batteries
-Error Messages
Warranty