Eagle 2000 - User Manual

Engineering Features
• Double Insulated for safety
• Plug-in Heating Element
• Built-in Over Temperature Control
• Electronic Temperature Control
• Listed with Underwriters Laboratories, Inc.
Specifications
Temperature Electronically adjustable from ambient
to 1200ºF (650ºC)
Air Flow Adjustable up to 15 CFM (400 I/mm)
Wattage 1600W @ 120/220 VAC
Voltage 120 or 220 VAC, 50/60 Hz
Weight 3 lbs. (1.45kg)
Operating Instructions
1. Make sure the voltage is the same as shown on the
nameplate.
2. Turn unit on using the rotary switch, set the unit to the
desired heat output. It takes approximately 4 minutes
for the tool to attain its full operating temperature.
3. When finished, cool the heating element down by
turning the rotary switch to position 1. This action will
extend the life of the heating element.
4. After the unit has cooled down, turn the tool off.
5. Clean any accumulated debris from the inlet screen.
The Eagle 2000 Hand-Held Heat Gun is made by The
Winston Group Ltd., a U.S. manufacturer.
WARNING
To reduce the risk of fire or electric shock, do not expose
this product to rain or moisture. Store indoors.
This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. Do not
modify the plug in any way.
CAUTION
Incorrect tool use can cause a fire. Be sure to lay the tool
on a fireproof surface when not in use. To avoid burns,
don not touch the heating element holder or nozzle while
the tool is in use. The tool should be protected from damp
or wet conditions. To insure tool safety, the carbon brush-
es should be checked and/or replaced after about 1600
hours of use.
MODEL 2000 HAND-HELD HEAT GUN
Compact, light-weight hot air hand-held gun for quickly and easily
welding seams of thermoplastic membranes or coated fabrics.
1092 Carolina Drive, Suite One West Chicago, IL 60185
Phone: 630.231.0419 Fax: 630.231.0429
E-Mail: sales@winstongroup.com Web: www.winstongroup.com
OWNERS MANUAL

Summary

Product Features and Specifications

Engineering Features

Details on the safety and control aspects of the heat gun, including insulation and temperature regulation.

Technical Specifications

Key performance data for the heat gun, covering temperature range, airflow, wattage, voltage, and weight.

Operating Instructions

Initial Setup and Operation

Steps for ensuring correct voltage, setting heat output, and allowing the tool to reach operating temperature.

Cool Down and Maintenance

Procedure for cooling the heating element to prolong its life and cleaning the inlet screen.

Safety Warnings and Precautions

General Safety Guidelines

Instructions for safe operation, including ventilation, work area preparation, and personal protective equipment.

Lead Paint Hazard

Crucial warnings and procedures regarding the dangers of lead-based paint removal with the heat gun.

Safe Work Practices

Recommendations for handling paint chips, dust, and waste safely, including cleaning and disposal methods.

Eagle 2000 Specifications

General

Brand	Eagle
Model	2000
Category	Power Tool
Language	English