FEATURES
1
2
3
4
5
6
7
8
9
10
11
Item NO by LED flash
Press button
Ignition on safety door lock
Passive arming & door lock
Passive immobilizer
Channel-2 output feature
Channel-3
Channel-4
Arm/Disarm chirp ON/OFF
Door unlock 1& 2 pulse
Door switch Anti car-jack
2-Way remote Check in-Range
Factory default setting
output feature
output feature
PROGRAMME MODE TABLE
1-chirp
2-chirp 3-chirp
Press once
Press twice
Press 3 times
W/O
*W/O
*W/O
*W/I
W/I
*2nd-killer
*Trunk open
*Window
*ON
*1pulse
OFF
2pulse
W/I
W/I
With door lock
Without door lock
Turbo
Dome Light
2nd stage
Unlock
Horn
Turbo
Turbo
Many of the operating settings of this unit are programmable. The programmable mode setting
dictates how the unit operates.
To enter programme mode and access Feature Change:
1. Disarmed the system, turn ignition from ON to OFF, within 10 seconds press valet Switch
ON-OFF for 8 times.
2. Siren will 2 long chirps sound and LED indicator ON to confirm the system is in programme
mode.
3.
*Exit programme mode: Under programming mode, if turning Ignition to ON , the system will
exit the programming mode and siren will give two chirps .
Note: if item No: 11 has been programmed, the system will auto exit the mode by given 2 chirps.
Under the programming mode (Features table may referring the following chart) ., Suppose
to set the function #5 :
press the (remote button for 5times) , Led will indicate flashing 5 times then pause per
cycle ., then you may press the (remote Button to selected the feature#5 enable
siren 1 chirp , or press again the button to disable the feature siren 2chirp. Again, If want
to set Item No.#10, press remote button for another 5times more then LED will indication
10time then pause per cycle (The quantity of led flashes is according to the numbers of
pressed Button ), then Press the Button to enable the feature #10 siren 1 chirp or
Press the button again to disable the feature, siren 2chirp. , and so on ..
Programme mode features:
Note: means factory default setting before delivery.
W/I : means with the feature W/O : means without the feature
*W/O
*W/O
W/I
W/I
-12-
Press button once, siren give 1 long
chirp and all features back to factory default.
To Next Page
Loading...
