Eaglemaster E2 - Alarm Page; Remote Button 1.2.3 On;Off

Alarm Page
If the alarm system is triggered while armed, an Alarm Page will be sent to the remote
control. When the remote receives an Alarm Page, the LED icons will display the alarm
system status information and the remote control will generate beeps.
Page Recognition (Acknowledgement)
To clear a page alert/notification, quickly press any button on the remote control. This
can be performed at any time during or after the page notification has occurred.
The remote control will not send a command to the system at this time; it will only clear
future repeats of the page notification. The next time a button is pressed on the remote
control it will send a command to the system.
Check in-range notification (programmable)
If programmed with the feature, after arming the system, main unit system will send 5-
signals to 2-Way remote within 6~7 minutes. If the 2-Way remote is out-range, the
remote responds with 2 long beeps and indicator flashing slowly .
Disable remote receiving
You may turn off the 2-Way remote receiving signal from the main unit. Press button
simultaneously for 2sec. until one long beep is heard. Remote receiving is now
disabled. To turn on receiving again, Press button simultaneously until two long
beep is heard, remote receiving is now enable.
Remote button 1.2.3 on/off
For safety purpose, this 2-way remote can be lockout the remote button in order not to
mis-touched the buttons. Press button for over 2sec. until one beep is heard, remote
button is now locked. To turn on remote button, press button for over 2sec. unitl two
beeps is heard, remote button is now unlocked.
Vibrate mode on/off (this feature may apply to the model "E2-LED-VB")
Press button for over 2sec. the 2-way remote will respond tone & vibrate feature,
the button pressing 2sec. will change the feature, see under table:
Display Beeps Vibrations Trigger
1-flash
flash within 20sec.
flash within 20sec.
flash within 20sec.
flash within 20sec.
Sensor warning
Shock sensor triggering
Door switch triggering
Hood / Trunk triggering
Ignition triggering
5 short
Melody 1
Melody 2
Melody 3
Melody 4
1 times
2 times periodically
3 times periodically
4 times periodically
5 times periodically
-4-
Programming 2-way remote
Beeps
2-way remote feature
Vibrations
1-beep
1-beep
1-time
1-time
Remote with tone and vibration
Remote with vibration only
Remote with tone only
NOTE: Vibrations features may apply to the model No: "E2-LED-VB".