Turbo mode:
If programmed , the CH-5 channel will constant output when ignition turn on 1 minutes. It will
keeps the engine running after arriving at your destination by ignition off for a programmed
time 1/ 3/ 5/ 10 minutes. This allows the system's timer to conveniently cool down the turbo
after you have left the vehicle.
Note: in turbo mode time , if arming the system, sensors will be bypassed and LED flashing
Green color for a programmed turbo time.
Important: Turbo mode should be used only in open areas. Never start and run the vehicle
in an enclosed space such as a garage or carport.
- Channel-6 (-) output(programmable):
This channel "Brown/black wire" is a negative (-500mA) output features, this channel can be
programmed : (1)- Arming output 1~120sec. (2)- Press button + output 1~120sec.
(1)- Arming output 1~120sec. if programmed, this channel will activate when arming, the
output timing can be programmed from 1 to 120seconds.
(2)- Press button + output 1~120sec. If programmed, to operate this channel by press
button + for over 2sec. This channel will constant output for programme time.
Note: When this channel is outputting, if press button + once, it will stop outputting.
- Channel-7 (-) output(programmable):
This channel "Black/white wire" is a negative (-500mA) output features, this channel can be
programmed : (1)- Disarming output 1~120sec. (2)- Press button + output 1~120sec.
(1)- Disarming output 1~120sec. if programmed, this channel will activate when disarming,
the output timing can be programmed from 1 to 120seconds.
(2)- Press button + output 1~120sec. If programmed, to operate this channel by press
button + for over 2sec. This channel will constant output for programme time.
Note: When this channel is outputting, if press button + once, it will stop outputting.
- Red/black programme (+) input:
This red/black (+) positive input can be programme three feature as:
- Reverse warning : If programmed , connect to the (+)reverse back light. when you are
reversing your car the siren will give a short warning chirp every one second.
Note: you can proceed the Reverse warning without siren chirps : (1) when you activated
the Disarm w/o chirp before Ignition On. (2) when you reversing the Car simply press
the button once.
- Head warning : If programmed , connect to the (+)head light . This feature will provide
pre-warning chirps if you forgot to turn off the head light while leaving the car.
- Extra sensor (knock sensor) : If programmed , connect to the (+) optional extra
sensor ( knock sensor). This feature will paging the 2way remote while trigger the sensor.
2-way LCD display
when armed:
-20-
NOTE:
you may disable this turbo mode
after ignition turn off ,by press
button once, the CH-5 will
stop outputting.
Flashing icon
2-way LCD display :
+ Melody sound
To Next Page
Loading...
