23
ACTIVE CALIBRATION PROCESS
The Eargo devices turn on 10 seconds after removing them from
the charger.
When first inserting your devices, they undergo an active calibration
process for 30-60 seconds. During this time they may ring a bit.
Don’t be alarmed - this is normal. It’s just the devices adjusting their
tuning to your specific ear canal. Kind of like how an orchestra takes
a minute or so to make sure they’re in tune with one another. You
don’t have an orchestra in your ear, but you know what we mean.
If the ringing doesn’t stop, try pulling back on the device ever so
slightly. This sometimes stops the ringing. You can also try rotating
the device slightly to make sure the microphone is not touching the
ear canal and causing feedback. If all else fails, remove the device
from your ear, place it in the charging cradle, remove it again and
re-insert the device into your ear.
To Next Page
Loading...
