32
Adjusting Sound Profile
AMPLIFICATION LEVELS
Your Eargo devices have four sound profiles (SPs), ranging from
low amplification (SP1) to maximum (SP4). To move from one SP
setting to the next, open your hand (as if you were going to clap)
and gently and rapidly double tap your ear.
Your Eargo device will let you know when you’ve changed SPs. With
every double tap your ear Eargo will say, “Program 1”, “ Program 2”,
“Program 3”, and “Program 4”. It will progress through all 4 levels
and then repeat from the beginning (SP 1-2-3-4, then back to SP 1-2-
3-4 etc.). Think of it as your volume carousel.
Sound settings are highly personal and often vary between ears
and in different settings. Each ear is different, so do this for each
ear independently. And remember, your Eargo devices should
make sounds and speech crisper, but not louder per se.
SP1 is a special setting that has lower amplification and a special
equalization curve designed for phone calls. When talking on a
phone, try this setting to reduce any potential feedback.
Your Eargo device will always stay on the last setting before
putting them in the charger. If you get a lot of feedback when
you insert the device, try tuning them down to Program 1
before putting them in the charger.
To get a sense of how rapid a double tap should be to change
SPs, visit us at eargo.com/showme to see a visual demonstration.
To Next Page
Loading...
