36210
Qty 2
36214
Qty 4
36200
Qty 4
36205
Qty 3
36300
Qty 17
36207
Qty 2
36305
Qty 2
33117
Qty 1
36105
Qty 1
36104
Qty 1
36103
Qty 1
36209
Qty 4
36404
Qty 18
For
C24HD
Only
Upper Handle
Gauge & Lever
Handle
Shaft
Frame
Brace
Cross
Brace
Lower
Handles
Impeller
Frame
Gearbox
Pivot
Control
Rod
Pivot
Rod
Axle
Foot
(Qty 4 #36214)
1/4-20 X 1½”
Phillips Panhead
(Qty 4 #36300)
1/4-20 SS Locknut
2. Position hopper on side. Install frame using (4) 1/4-20 x 1 ½” Pan Head Phillips machine
screws and (4) 1/4-20 nylon insert locknuts. First put bolts through holes in frame then through
holes in bottom of hopper. Secure with locknuts. TIGHTEN THESE LOCKNUTS NOW.
1. Remove and identify all of the loose parts from carton.
8-2014 Pt# 52142 PAGE 1
Gauge Overlay is snapped
over the metal gauge. Replace
the stop bolt assembly to se-
cure overlay on the gauge.
WARNING
Do not use air tools to assemble. To prevent
seizing, spray all nuts & bolts with oil, grease,
wax, or other lubricant.
PLEASE CONTACT US: IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY
QUESTIONS REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME
TECHNICAL SUPPORT. SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: techsupport@earthway.com
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The
impeller must turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller
after each use as some fertilizer may become stuck on the impeller blades and will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and ow rate. Clean and dry your
spreader thoroughly after each use, wash between the shut-off plate and bottom of the hopper regularly. To prevent
rust, coat all metal parts (inside and out) including the chassis tubes with a light oil or corrosion preventative spray. Wash
between the shut off plate and bottom of the hopper and allow to dry before next use..
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
; If you use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock
Salt will reconstitute back into a solid block if left in the hopper overnight and will damage your gearbox if pushed with the
block in place.
ROCK SALT AND POWDERED MATERIALS SHOULD
NOT BE USED IN THIS SPREADER AS IT WILL DAMAGE
GEARBOX AND CAN VOID WARRANTY.
USE ONLY GRANULAR MATERIALS.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7
MADE IN THE USA
C24HD & C24HDS
Assembly And OperAting instructiOns
To Next Page
Need help?
General
