2
Frame
Upper handles
Gauge &
Linkage
Assembly
Handle Shaft
Lower
Handles
Wheels
Impeller
Gearbox
Axle
Control Rod
1. Remove and identify all loose parts from carton.
#10 X 1-1/4”
Flat Head Screw
PAGE 1
; Make sure the on the gear box points to the front of the spreader. The impeller must turn clockwise.
Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each
use. Fertilizer stuck on the impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns. Wet fertilizer will also change the spread pattern and ow rate.
Clean and dry your spreader thoroughly after each use. A coating of light spray oil on all metal parts will help
prevent corrosion, pay special attention to coating the inside of the steel tubing.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER, PLEASE CONTACT US. THIS MODEL INCLUDES LIFETIME TECHNICAL
SUPPORT
2. Position hopper as shown to the
right. Install Frame using (4) #10
x 1¼” Flat Head Phillips screws.
3. Install gear box by inserting the pinion shaft into hole in center
of hoppers bottom. The on the gearbox must point to
of the hopper. Follow label instructions on hopper.
F
R
O
N
T
Arrow
Warning
To Next Page
Need help?
General
