31104
Qty 4
32100
Qty 2
33117
Qty 1
31100
Qty 4
31120
Qty 4
32103
Qty 8
31106
Qty 2
33108
Qty 1
33109
Qty 1
12152
Qty 2
12148
Qty 2
44249
13
16
17
31
24
28
23
25
26
11
12
38
29
9
1. Remove and identify all loose parts from carton.
(Qty 4) #31104
#14 X 1-1/2”
Flat Head Screw
2. Position hopper as shown at the left. Install FRAME using (4) #14 x 1½” Flat
Head Phillips screws. TIGHTEN THESE NOW
11-21-2017 Pt# 52157 PAGE 1
2150 Commercial
Broadcast Spreader with SSC
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: techsupport@earthway.com
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
; If your spreader does not spread evenly, be sure “FRONT” on the GEARBOX points to the front of the spreader.
The impeller must turn clockwise when pushing forward. Reversing the GEARBOX will cause the impeller
to turn counter clockwise. Clean the impeller plate after each use. Fertilizer stuck on the impeller blades will
cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns. Wet fertilizer will also change the spread pattern and ow rate.
Clean and dry your spreader thoroughly after each use. Coat all metal surfaces (inside & outside of tubing)
with light oil, Fluid Film
®
or silicon spray to help prevent corrosion. Wash between the shut o plate and bottom
of the hopper. Do not use powdered materials as it will damage the gearbox.
; Gears are permanently lubricated at the factory. Do not open the GEARBOX or dirt may enter.
ROCK SALT and POWDERED
MATERIALS should not be used in
this spreader as it will damage the
GEARBOX and can void the warranty.
Use only granular materials.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7