EarthWay 2150 - Assembly Instructions Manual

50 lb Commercial Spreader
with Side Spread Control
MODEL # 2150 ASSEMBLY INSTRUCTIONS
Earthway 2150 Manual PAGE 1
Prior to assembly, you will
need the following tools:
Needle nose pliers
#2 Phillips screwdriver
Adjustable wrench or ½″
box wrench
ROCK SALT and POWDERED MATERIALS should not be
used in this spreader as it will damage the gearbox and
can void warranty. Use only granular materials.
SIDE SPREAD CONTROL
Your EarthWay spreader includes a feature called side
spread control. This feature turns off fertilizer from being
spread to the left side. To activate this feature, slide the
lever below the hopper to the right (if standing behind the
spreader) and walk along a sidewalk or flowerbed that is
12″-14″ on your left side. Fertilizer will not spread to the
left. This feature is better than a deflector as no material is
wasted by the deflector.
ASSEMBLY HARDWARE
SPREADER COMPONENTS
M6 x
4 x
40m
m
Agitator
M6 X
2 X
40M
M
Hog
Ring
M6 x 2 x
55mm
25mm
50 mm
40 mm
60 mm
70
mm
Bearing
Bushing
M6 X
10
M6 X 2
M6 X 5 X
60 mm