EasyGate Terrier 200 - SW2: Delays, Deceleration & Speed; SW2: Single;Double Gate Operation

9
The auto close timer will start when the gates are either fully open or stopped through
a cycle. Activating a remote or any other device will override the timer and close the
gates immediately.
SW1 Pedestrian Mode
This function will open one side of the gates to a 45 degree angle to allow pedestrians
through. It is activated by pressing the top RIGHT button on your remote. Please note:
Only for double gate operation.
Switches: 7
7 on
One gate will open half way.
7 off
Pedestrian mode is disabled
SW1 Flashing light
The flashing light can be set to blink before it starts opening the gate (It will flash while
opening the gate no matter what).
Switches: 8
8 on
The flashing lights blink for 3 seconds before the gate moves.
8 off
No 3 second flashing.
The following functions are all on SW2 (middle block of switches).
SW2 Close and open delay
This is the delay between activating your remote/keypad and for the gates to start
moving.
Switches: 3 and 4
Open delay
Close delay
3 off
4 off
2 seconds
3 seconds
3 on
4 off
2 seconds
4 seconds
3 off
4 on
3 seconds
5 seconds
3 on
4 on
3 seconds
6 seconds
SW2 Deceleration of the motors
The last part of the closing cycle slows the gate down just before they finish opening
or closing. This alters the slowed speed of the closing cycle.
Switches: 6
6 on
Speed slows down to 70%
6 off
Speed slows down to 50%
SW2 Operating speed
This is the amount of speed the gates will swing at during their normal operating
speed.
Switches: 7
7 on
Speed is 100% of maximum speed
7 off
Speed is 70% of maximum speed
SW2 Single and double gate operation
This function is to program in if you have a single gate or a double gate.
Switches: 8
8 on
Double gate
8 off
Single gate