EasyIO FG32 - Login Details

EasyIO FG32 – Installation Guide v2.0
17
LED Conditions
Description
Pattern: continuously blinking.
ERR is to indicate whenever there is
1
ERR
Communication errors.
Pattern: constantly light up.
The controller is undergoing firmware
upgrading. This is normal during firmware
upgrade process.
STS is used to indicate the heartbeat of the
2
STS
Microcontroller. The STS LED will blink at
1-second interval in normal operation
Condition.
TXRX is used to indicate when there are
3
TX1 RX1
Communication activities in Port 1.
(Transmitting or Receiving) on the
Communication port.
TXRX is used to indicate when there are
4
TX2 RX2
Communication activities in Port 2.
(Transmitting or Receiving) on the
Communication port.
Login Details
EasyIO FG and FG+ Series details are as below.
Sedona Login
Username : admin
Password : <no password>
FTP client Webuser Login
This login allows user to edit the web files or view CPT graphics deployment files.
Username : webuser
Password : 123456
FTP client Sdcard Login
This login allows user to upgrade firmware
Username
: sdcard
Password
: 123456
Default IP address
: 192.168.10.11
Default Subnet
: 255.255.255.0
Default Gateway
: 192.168.10.11
Note :
In order to login, the host PC (laptop) has to be in the same subnet. Example:
IP address : 192.168.10.123
Subnet : 255.255.255.0