EasyIO FG32 – Installation Guide v2.0
18
Changing IP address
By default the EasyIO FG and FG+ Series controller IP address is 192.168.10.11.
Changing the IP address can only be done through CP T tools.
Step 1
Login to the FG32 via Sedona workbench. Locate the object “IP” under the Service folder.
Step 2
Click IP object and view properties at the side bar.
At the newIpAddress, newSubnetMask and newGateway property, enter your new IP address.
Inserting invalid values to these properties will brick the network settings.
A restore factory default is required if controller unable to connect.
currentDhcp and newDhcp property only supported by FS Series controllers.
Ignore these properties if the hardware is FG and FG+.
To Next Page
Loading...
