What to do if my Eaton 5P1000RC UPS is beeping with the battery light on?
If the Eaton UPS is beeping every 10 seconds and the battery LED is on, it means a utility failure has occurred, and the UPS is now running on battery power. The UPS is using battery power to keep your equipment running. You should prepare your equipment for shutdown.
Why does my Eaton UPS beep every 3 seconds?
If your Eaton UPS beeps every 3 seconds, it means the UPS is running on battery, and the battery is getting low. Be aware that this is an approximate warning, and the actual time remaining before shutdown can vary significantly. The 'Battery Low' warning might appear before the battery reaches 20% capacity, depending on the UPS load.
What does it mean when my Eaton 5P1000RC beeps every 10 seconds in AVR mode?
If your Eaton UPS beeps once every 10 seconds while in AVR mode, it indicates that the utility voltage is outside of the normal range. The UPS is using Automatic Voltage Regulation to power your equipment, which is still protected.
How to fix the 'end of battery life' error on my Eaton 5P1000RC?
If your Eaton UPS indicates the end of battery life, it means the batteries need replacing. Contact your service representative to arrange for a battery replacement.
What to do if my Eaton UPS is overloaded?
If your Eaton UPS reports an overload, it means the power demand from connected devices exceeds its capacity (more than 105% of its rating). To resolve this, disconnect some equipment from the UPS. The UPS will keep working, but may shut down if the load increases further. The alarm will clear once the overload condition is resolved.
What to do if my Eaton 5P1000RC UPS has a fault?
If your Eaton UPS displays a fault, it indicates an internal issue. In this state, the UPS no longer protects connected equipment. Record the alarm message and the UPS serial number, and then contact your service representative.
To Next Page
General
