Why is the INVERTER LED lighting up with beeping every 4 seconds on my Eaton UPS?
If the INVERTER LED on your Eaton UPS is lit and an audible alarm beeps every 4 seconds, it means the main power supply has failed. The system is automatically switching to battery mode. Note that when the alarm sounds every second, the battery is almost empty.
How to fix LINE LED blinking on Eaton UPS?
If the LINE LED on your Eaton UPS is blinking, it indicates that the phase and neutral conductors at the UPS input are reversed. Rotate the mains power socket by 180° or correctly connect the UPS system.
What to do if Eaton 6000H UPS FAULT LED lights up and warning alarms once a second?
If the Eaton UPS FAULT LED lights up and a warning alarm sounds once per second, it indicates an overload. To resolve this, remove some of the connected devices from the UPS output.
Why is the emergency supply period shorter than nominal value on my Eaton UPS?
If your Eaton UPS emergency supply period is shorter than expected, it could be due to batteries not being fully charged or defective batteries. Charge the batteries for at least 1-2 hours and then check their capacity. If the problem persists, it is recommended to consult with your dealer.
Why are LINE and BYPASS LED lights on even though the power supply is available on Eaton UPS?
If the LINE and BYPASS LEDs are lit on your Eaton UPS even when power is available, the inverter may not be switched on. Press the On-Switch “I” to activate the inverter.
What does it mean when the FAULT LED lights, BATTERY-LED blinks, warning alarms once a second on Eaton 6000H?
If the FAULT LED is lit, and the BATTERY LED is blinking, accompanied by warning alarms once a second on your Eaton UPS, it suggests that the charger or batteries are damaged. It is recommended to notify your dealer for assistance.
Why is the LINE-LED blinking and BATTERY-LED lighting up on my Eaton UPS?
If the LINE LED is blinking and the BATTERY LED is lit on your Eaton UPS, it means the input power and/or frequency are out of tolerance. Check the input power source. If the problem persists, contact your dealer.
How to troubleshoot no indication on Eaton 6000H?
If your Eaton UPS shows no indication and no warning tone, even when connected to the mains power supply, it suggests there is no input voltage. Check the building wiring socket outlet and the input cable.
Guidelines for installing the UPS in various environments and specific model considerations.
Procedures and precautions for operating the UPS safely.
Safety precautions for maintenance, including handling batteries and fuses.
Specific warnings for all models and for 6000H/10000H models.
Detailed instructions for installing the 1000H/2000H/3000H models.
Instructions for installing the 6000H/10000H models.
Procedures for turning the UPS on and off in different modes.
Troubleshooting guide for 1000H/2000H/3000H models.
Troubleshooting guide for 6000H/10000H models.
General| Real Power | 5400 W |
|---|---|
| Frequency Range | 50/60 Hz |
| Topology | Double Conversion Online |
| Efficiency | Up to 94% |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Communication Ports | USB, RS-232 |
| Power Rating | 6000 VA / 5400 W |
| Form Factor | Rack/Tower |
To Next Page