9130 firmware upgrade guide 1028349 Rev. P4
2012, Eaton Corporation Page 6 of 11
7. Press button when the following Popup Message Box
should appear:
Note. If the message below will appear instead, return to item 1 in this
procedure to verify the cabling, COM port settings and that the UPS is in
standby state.
8. Unplug the input power cord from the UPS and click
. The
flashing will begin after a few seconds.
Note. If “Flash firmware NG!” message will appear during the flashing, go
to Chapter 1.3 DSP Firmware Upgrading via RS-232 – Flash Error.
To Next Page
Loading...
