Eaton 9140 - Installing the EBM Batteries

INSTALLATION
Eaton 9140 EBM User's Guide S 164201623 Rev C www.eaton.com/powerquality
21
8. Place the EBM on a flat, stable surface with the front of the EBM
facing toward you.
9. If the front and rear mounting brackets are already installed, skip to
Step 12. If the brackets are not already installed, continue to
Step 10.
10. Align the two front mounting brackets with the screw holes on the
sides of the EBM and secure with eight supplied M4 flat-head
screws (see Figure 6).
11. Align the two rear mounting brackets with the lowest two screw
holes on the sides of the EBM and secure with four supplied M4
flat-head screws.
Front Mounting
Brackets (2)
Rear Mounting
Brackets (2)
Figure 6. Installing the EBM Front and Rear Mounting Brackets