8. Remove the shipping brackets.
NOTE: After you have removed the shipping brackets, move the unit immediately
away from the pallet.
After you have removed the shipping brackets and retracted the leveling feet, do
not use a forklift to move the unit while it is still on the pallet. Note that the UPS
cabinet is heavy and there are casters under the cabinet.
9. Slowly roll the cabinet toward the ramp edge. Be careful not to push the
cabinet too much or too fast since it may cause the cabinet to tip over. Note
that the cabinet is heavy. Make sure that you have enough manpower to
handle and support the unit while rolling it off the pallet.
10. Roll the cabinet to its final installation location.
© Eaton Corporation plc 2020. All rights reserved. Revision: 006 Document ID: P-164000493 58 (126)
Eaton 91PS/93PS UPS 8–40 kW User’s and Installation Guide
To Next Page
Loading...
