Eaton 9SX 15K Series - Page 24

24
III. Bridge the ‘AC segment terminal L1/L2/L3’ with ‘busbar #3’, then connect the
AC cable(L) to it
3. Connection to the UPS:
I. Remove all busbars from the UPS
II. Connect the UPS to MBP with the ‘Cable to UPS1’ included in the MBP’s
accessory
3.1.3 Mode 3-3(single source) ：
1. Input:
I. Connect the main-ground cable (PE) to the chassis
II. Bridge the ‘AC input terminal N/N’ with ‘busbar #1’, then connect the AC cable
(N) to it
III. Bridge the ‘AC input terminal mL1/bL1’ with ‘busbar #1’, then connect the AC
cable (L1) to it