25
IV. Bridge the ‘AC input terminal mL2/bL2’ with ‘busbar #1’, then connect the AC
cable (L2) to it
V. Bridge the ‘AC input terminal mL3/bL3’ with ‘busbar #1’, then connect the AC
cable (L3) to it
2. Output:
I. Connect the ground cable (PE) to the chassis
II. Bridge the ‘AC segment terminal N/N’ with ‘busbar #1’, then connect the AC
cable (N) to it
III. Connect the ‘AC segment terminals L1/L2/L3’ to the AC cables (L1/L2/L3)
3. Connection to the UPS:
I. Remove all the busbars of the UPS
II. Connect the UPS to MBP with the ‘Cable to UPS1’ included in the MBP’s
accessories
3.1.4 Mode 3-3(Dual source)
To Next Page
Loading...
