⚫ Dangerous voltage levels are present within the system. It should be opened
exclusively by qualified service personnel.
⚫ High leakage current may be present. Earth connection is essential before
connecting to the supply.
⚫ Precautions must be taken for all handling, Wear rubber gloves and boots.
Product Safety
⚫ The MBP connection instructions and operation described in this manual
must be followed in the indicated order.
⚫ The upstream circuit breaker for Normal AC / Bypass AC must be easily
accessible so that the unit can be disconnected from AC power source by
opening this circuit breaker.
⚫ An additional AC contactor should be used for backfeed protection and must
comply with IEC/EN 62040-1 (the creepage and clearance distances shall meet
the basic insulation requirements for pollution degree 2).
⚫ Disconnection and overcurrent protection devices shall be provided by others
for permanently connected AC input (Normal AC/Bypass AC) and AC output
circuits.
⚫ Check that the indications on the rating plate corresponds to your AC
powered system and to the actual electrical consumption of all the equipment
to be connected to the system.
⚫ For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the
equipment and shall be easily accessible
⚫ Never install the system near liquids or in an excessively damp environment.
⚫ Never let a foreign object penetrate inside the system.
⚫ Never block the ventilation grates of the system.
⚫ Never expose the system to direct sunlight or source of heat.
⚫ If the system must be stored prior to installation, storage must be in a dry
place.
⚫ The admissible storage temperature range is -25°C to +60°C.
Special precautions
⚫ The unit is heavy: wear safety shoes and use vacuum lifter preferentially for
handling operations.
⚫ All handling operations will require at least two people (unpacking, lifting,
To Next Page
Loading...
