41
cable (L3) to it
2. Output:
I. Connect the ground cable (PE) to the chassis
II. Bridge the ‘AC segment terminal N/N/N’ with ‘busbar #3’, then connect the AC
cable (N) to it
III. Connect the ‘AC segment terminal L1/L2/L3’ to AC cable (L1/L2/L3)
3. Connecting to UPS 1 and UPS 2:
III. Remove all busbars of the UPS
IV. Connect UPS 1 and UPS 2 to the MBP with ‘Cable to UPS 1’ and Cable to UPS
2’ included in the MBP’s accessory
3.3.4 Mode 3-3(Dual source)：
To Next Page
Loading...
