Eaton 9SX 20KPM Series - Page 55

54
[High Efficiency]
[Frequency]
Output Voltage
[220V] [230V] [240V]
Output Frequency
[Auto Detection] [50Hz] [60Hz]
ESS Function
[Enabled] [Disable]
Auto Bypass
[Enabled] [Disable]
Auto Restart
[Enabled] [Disable]
Clear SC Fault
[Enabled] [Disable]
Overload Prealarm
[50%,105%]
Battery
DC Start
[Enabled] [Disable]
Battery Auto Test
[Every ABM Cycle][ Disable]
Deep Discharge protection
[Enabled] [Disable]
Sleep mode
[Enabled] [Disable]
Low Battery Warning
[0%,100%]
Low Remind Time Warning
[0,999min]
Restart Battery Level
[0%,100%]
Charge Current
[1A~13A]*
Extearnal Battery Module
[Auto Detection]
[External Battery Setting EBM]
[External Battery Setting AH]
Dry In/Out
Dry Contact Input Signal
[No Function]
[Start Up]
[Shut Down]
[Maintainance]
Dry Contact Output Signal
[Load Supply]
[Battery Mode]
[Battery Low Voltage]
[Battery Detatched]
[Bypass Output]
[UPS Normal]
ModBus Address
[1-255]
Password
Setting Password
[Enabled] [Disable]
Control Password
[Enabled] [Disable]
Change Password
****
* When connecting to external batteries, please refer to the table below to set the charge current
and AH value.