Eaton BladeUPS - Page 18

INSTALLATION
Eaton BladeUPS Bar Installation Guide S 164201723 Rev 2 www.eaton.com/powerquality
14
20. Using five M4 8 pan-head screws, install the wireway access
cover. See Figure 8. Torque the screws to 1.7 ± 0.2 Nm
(15 ± 2 lb in).
M4 8 Pan-Head Screws
(5 places)
Wireway Access Cover
Rear of Rack
Figure 8. Wireway Access Cover Installation
21. Verify that the six information labels are attached to the wireway as
shown in Figure 9.
Labels
Figure 9. Wireway Labels