Need help?Do you have a question about the Eaton BladeUPS Series and is the answer not in the manual?
General| Topology | Double conversion online |
|---|---|
| Frequency | 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Humidity | 0% to 95% non-condensing |
| Efficiency | Up to 96% efficiency in double conversion mode |
| Battery Type | VRLA (Valve Regulated Lead Acid) |
| Communication | RS-232, USB, SNMP |
| Scalability | Scalable from 12kW to 60kW in a single rack |
Details the components of the BladeUPS system as shipped.
Instructions for installing battery chassis support brackets onto crossbars.
Procedure for removing the top and bottom battery cover plates from the BladeUPS module.
Ensuring input circuit breakers CB1 and CB2 are turned off before proceeding.
Steps to reinstall the battery cover plates after battery installation.
Connecting the front control panel display cables to the EM RJ-45 connectors.
Procedure for tapping into the power line for proper voltage connection.
Connecting the input-output wire for each UPS module.
Installing Hot Sync CAN Bridge Cards into the UPS X-Slot bays.
Installing blue terminating plugs into the CAN IN and CAN OUT ports.
Connecting the CAN bridge card cable between UPS units.
Installing the redundant signal cable between UPS units.
Connecting the bypass switch contact cable between UPS units.
Lists the available UPS and EBM model numbers.
Provides physical specifications for UPS and Extended Battery Modules.
Details the voltage, frequency, and connection types for electrical input.
Details the voltage, current, and overload capabilities of the electrical output.
Outlines operating conditions, safety standards, and environmental ratings.
Provides details on battery configuration, type, and charging.
To Next Page
