Replacing the control
To place a control into the control enclosure, follow the
procedure outlined below:
1. Engage control on enclosure hinges.
2. Connect control ground lead to back panel.
3. Reconnect control to back panel at TB2, located at the
bottom of back panel.
4. Push closed disconnect switch V1 (and V6 if present).
5. Pull open current shorting switch C.
6. Close control and tighten locking screws.
17
CL-6 SERIES CONTROL INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS MN225016EN January 2016
To Next Page
Loading...
