Eaton easyE4 - 1. Description of easyE4 control relay; 1.1 Use as intended

Application Note Establish Ethernet connection between easyE4 and easySoft V7 04/2020 AP050013ENEN www.eaton.com 19
15. The IP address of the easyE4 is offered for selection under "Interface".
16. Go online.
17. The easyE4 to which you are now connected is displayed on the work surface.
transfer your project by clicking on "PC => Device".
NOTE: When downloading the *.e70 project, the IP settings from the register "Ethernet" (view
"Project") are transferred to the easyE4. Depending on how these are set (i.e. different from
those in the IP profile currently used for the connection), the Ethernet connection to the
easyE4 is terminated immediately after downloading the *.e70 project. If you would like to
establish a new connection, create an IP profile as interface with the previously transferred IP
settings.
18 . Start the program by clicking on "RUN".
16.
15.
17.
18.
19.