Eaton ELC-PB - Page 86

2. Programming Concepts
MN05003003E For more information visit: www.eaton.com
2-57
Special D
Function
ELC
-PB
ELCB
-PB
ELC
-PC
-PA
-PH
ELCM
-PH
- PA
ELC
-PV
OFF
Ø
ON
STOP
Ø
RUN
RUN
Ø
STOP
Type Latched
Factory
setting
D1028
Index register E0
Y Y Y Y 0 - - R/W NO 0
D1029
Index register F0
Y Y Y Y 0 - - R/W NO 0
D1030
Output numbers of Y0 pulse (Low
word)
Y Y Y - 0 - - R NO 0
D1031
Output numbers of Y0 pulse (High
word)
Y Y Y - 0 - - R NO 0
D1032
Output numbers of Y1 pulse (Low
word)
Y Y Y - 0 - - R NO 0
D1033
Output numbers of Y1 pulse (High
word)
Y Y Y - 0 - - R NO 0
D1035
No. of input point X as RUN/STOP
- - - Y - - - R/W YES 0
D1036
COM1 (RS-232) Communications
protocol
Y Y Y Y 0086 - - R/W NO 0086
D1037
Repetition time of HKY key
- - - Y - - - R/W NO 0
D1038
When the ELC is a slave, this sets the
data response delay time. Time base
is 0.1ms.
When the ELC is using ELC-Link,
D1038 can be set to send the next
communication data message with this
delay. (Unit: one scan cycle; for ELC-
PC/PA/PH, for ELCM-PH/PA: 1 scan
cycle; for PV: 0.1ms)
Y Y Y Y - - - R/W NO 0
D1039
Constant scan time (ms)
Y Y Y Y 0 - - R/W NO 0
D1040
ON state number 1 of STEP point S
Y Y Y Y 0 - - R NO 0
D1041
ON state number 2 of STEP point S
Y Y Y Y 0 - - R NO 0
D1042
ON state number 3 of STEP point S
Y Y Y Y 0 - - R NO 0
D1043
ON state number 4 of STEP point S
Y Y Y Y 0 - - R NO 0
D1044
ON state number 5 of STEP point S
Y Y Y Y 0 - - R NO 0
D1045
ON state number 6 of STEP point S
Y Y Y Y 0 - - R NO 0
D1046
ON state number 7 of STEP point S
Y Y Y Y 0 - - R NO 0
D1047
ON state number 8 of STEP point S
Y Y Y Y 0 - - R NO 0
D1049
ON number of alarm point
- Y Y Y 0 - - R NO 0
D1050
↓
D1055
ELC will automatically convert the
ASCII data saved in D1070~D1085 to
HEX.
Y Y Y Y 0 - - R NO 0
D1056
Present value of PA controller analog
input channel 0 (CH0)
- Y 0 - - R NO 0
D1057
Present value of PA controller analog
input channel 1 (CH1)
- Y 0 - - R NO 0
D1061
Error record of non-latched area
Y Y - Y - - - R YES 0