Eaton ELC-PB - Page 87

ELC Programming Manual
FOR MORE INFORMATION VISIT: WWW.EATON.COM MN05003003E
2-58
Special D
Function
ELC
-PB
ELCB
-PB
ELC
-PC
-PA
-PH
ELCM
-PH
- PA
ELC
-PV
OFF
Ø
ON
STOP
Ø
RUN
RUN
Ø
STOP
Type Latched
Factory
setting
D1062
For ELC-PA controllers, sampling
range of AD (CH0, CH1): 2~4
- Y - - - 2 - R/W NO 2
D1063
For ELCM-PA controllers: sampling
range of AD0～AD3 (CH0~CH3)):1~20
- - Y -
D1064
ELC flash ROM access function for
program, password and data.
ELC reads flash: H55AA
ELC writes flash: HAA55
- - - Y 0 - - R/W NO 0
D1067
Algorithm error code
Y Y Y Y 0 0 - R NO 0
D1068
Lock the algorithm error address
Y Y Y Y 0 - - R NO 0
D1070
↓
D1085
When the ELC’s built-in RS-485
communication instruction receives
feedback signals from receiver. The
data will be saved in the registers
D1070~D1085. User can use the
contents saved in the registers to
check the feedback data.
Y Y Y Y 0 - - R NO 0
D1086
ELC-ACPGMXFR
High word of password setting (Display
by HEX value corresponding to ASCII
word)
Y Y Y Y 0 - - R/W NO 0
D1087
ELC-ACPGMXFR
Low word of password setting (Display
by HEX value corresponding to ASCII
word)
Y Y Y Y 0 - - R/W NO 0
D1089
↓
D1099
When the ELC built-in RS-485
communication instruction is executed,
the transmitting signals will be stored
in the registers D1089~D1099. User
can use the contents saved in
registers to check the feedback data.
Y Y Y Y 0 - - R NO 0
D1100
Corresponding status after LV signal is
enabled
- - - Y 0 - - R/W NO 0
D1101
Start address of file register
- Y - Y - - - R/W Yes 0
D1102
Copy numbers of file register
- Y - Y - - - R/W Yes 1600
D1103
Set start D number for file register to
store (the number should be large than
2000)
- Y - Y - - - R/W Yes 2000
D1104
Parameter index for Accel/Decel pulse
output Y0 (corresponds to device D)
Y Y - - 0 0 - R/W NO 0
D1109
COM3 (RS-485) Communication
protocol
- - Y - 0086 - - R/W NO 0086