Eaton ELC-PB - Page 90

2. Programming Concepts
MN05003003E For more information visit: www.eaton.com
2-61
Special D
Function
ELC
-PB
ELCB
-PB
ELC
-PC
-PA
-PH
ELCM
-PH
- PA
ELC
-PV
OFF
Ø
ON
STOP
Ø
RUN
RUN
Ø
STOP
Type Latched
Factory
setting
D1137
Address of operator error occurs
Y Y Y Y 0 0 - R NO 0
D1140
Special expansion module number,
maximum is 8 modules
Y Y Y Y 0 - - R NO 0
D1142
Input points (X) of expansion module
Y Y Y Y 0 - - R NO 0
D1143
Output points (Y) of expansion module
Y Y Y Y 0 - - R NO 0
D1144
Parameter index for Accel/Decel pulse
output Y0 of adjustable slope
(corresponds to component D)
- Y - - 0 - - R/W NO 0
D1145
Number of left-side special expansion
modules (max. 8)
- - - Y 0 - - R NO 0
D1150
Table count register in multi-group
setting comparison mode of DHSZ
command
- - - Y 0 0 0 R NO 0
D1151
Table counting register for DHSZ
multiple set values comparison mode
- - - Y 0 0 0 R NO 0
D1152
High word of changed D value for
DHSZ instruction
- - - Y 0 0 0 R NO 0
D1153
Low word of changed D value for
DHSZ instruction
- - - Y 0 0 0 R NO 0
D1154
Recommended Interval of accelerated
time (10~32767 ms) of Accel/Decel
pulse output Y0 of adjustable slope
- Y - - 200 - - R/W NO 200
D1155
Recommended Interval of decelerated
time (-1~ -32700 ms) of Accel/Decel
pulse output Y0 of adjustable slope
- Y - - -1000 - - R/W NO -1000
D1166
Exchange of X10 rising/falling-edge
count modes (for ELC-PH only)
- Y - - 0 - - R/W NO 0
ELC-PH: Exchange of X11
rising/falling-edge count modes.
- Y - -
D1167
The specific end word to be detected
for RS instruction to execute an
interruption request (I140) on COM1
(RS-232).
- - Y -
0 - - R/W NO 0
D1168
RS instruction on COM2, interrupt
request when receiving specified data
character (I150)
- Y Y 0 - - R/W NO 0
Interruption request for receiving
specific word in RS instruction on
COM2 (I160)
- - - Y
D1169
RS instruction on COM2, interrupt
request when receiving specified data
character (I160)
- - Y -
0 - - R/W NO 0
D1170
PC value when executing single step
- - - Y
0 0 0 R NO 0
D1172
2-phase pulse output frequency
(12Hz~20KHz)
- Y - - 0 - - R/W NO 0
D1173
2-phase pulse output mode selection
(K1and K2)
- Y - - 0 - - R/W NO 0