Eaton ELC-PB - Page 89

ELC Programming Manual
FOR MORE INFORMATION VISIT: WWW.EATON.COM MN05003003E
2-60
Special D
Function
ELC
-PB
ELCB
-PB
ELC
-PC
-PA
-PH
ELCM
-PH
- PA
ELC
-PV
OFF
Ø
ON
STOP
Ø
RUN
RUN
Ø
STOP
Type Latched
Factory
setting
D1123
Residual words of receiving data
Y Y Y Y 0 0 - R NO 0
D1124
Start character definition (STX)
Y Y Y Y 003A - - R/W NO 003A
D1125
First ending character definition
(ETX1)
Y Y Y Y 000D - - R/W NO 000D
D1126
Second ending character definition
(ETX2)
Y Y Y Y 000A - - R/W NO 000A
RS instruction, interrupt request when
receiving specified data character
(I150)
Y - - - 0 - - R/W NO 0
D1127
Number of pulses for ramp-up
operation of positioning instruction
(Low word)
- - Y - 0 - - R NO 0
D1128
Number of pulses for ramp-up
operation of positioning instruction
(High word)
- - Y - 0 - - R NO 0
D1129
Number of pulses for ramp-up
operation of positioning instruction
(Low word)
Y Y Y Y 0 - - R/W NO 0
D1130
MODBUS return error code record
Y Y Y Y 0 - - R NO 0
D1131
Input/output percentage value of
CH0(Y0,Y1) close loop control
- - Y Y 100 - - R/W NO 100
D1132
Input/output percentage value of
CH1(Y2,Y3) close loop control
- - Y Y 100 - - R/W NO 100
Special high-speed pulse output Y0
(50KHz) register (D) index (PC/PA)
- Y - -
Y10 outputs the starting number of
register (D) for two-axis synchronous
control(ELC-PH)
- Y - -
D1133
Number of pulses for ramp-down
operation of positioning instruction
(Low word)
- - Y -
0 - - R/W NO 0
Set the number of segments of Y10
output for two-axis synchronous
control (For ELC-PH only)
- Y - -
D1134
Number of pulses for ramp-down
operation of positioning instruction
(High word)
- - Y -
0 - - R/W NO 0
Y11 outputs the starting number of
register (D) for two-axis synchronous
control (For ELC-PH VERSION 1.4
and above only)
- Y - -
D1135
Pulse number for masking Y2 when
M1158 = ON (Low word)
- - Y -
0 - - R/W NO 0
Set the number of segments of Y11
output for two-axis synchronous
control (For ELC-PH_VERSION 1.4
and above)
- Y - -
D1136
Pulse number for masking Y2 when
M1158 = ON (High word)
- - Y -
0 - - R/W NO 0