Eaton i-onEX Series - Allowing a FOB-2 W-4 B or 727 R to Start a HUA

i-on40 & i-onEX Range 4. Administration
Page 101
Allowing a FOB-2W-4B or 727r to start a HUA
You may wish to allow a user to start a Hold Up Alarm from a 727r remote
control or a FOB-2W-4B two-way fob. The Installer must first program the
control unit to allow this (note that doing so will mean that the system no
longer complies with BS8243 or DD243). Once the Installer has enabled
the feature, you can enable the remote control or FOB-2W-4B as follows:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  until you see:.


5. Press .


6. Press  until the display shows:


7. Press .


8. Press  until the display shows:


9. Press .
The display shows:


10. Press . or  until the display
shows:


11. Press 
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


12. Press  repeatedly to leave the
menu.