Eaton i-onEX Series - Page 29

i-on40 & i-onEX Range 3. Setting and Unsetting
Page 23
The bottom line of the display
shows each item from the rest of
the menu in turn.
b. Press .
Go to: 3. Finishing Setting on
page 24.
Partitioned Systems
Do this:
The display shows:
The bottom line of the display
shows the first item in the setting
options menu.
If any partition is already set then
the system will skip to point b.
↕

a. Press  or  to show “Partitions”.
“Partitions” is the second item
down on the setting options menu
(or third if a part set is available).
↕

b. Press .
The bottom line of the display
shows the state of the first
partition:
U = Unset
S = Full Set
P = Part Set
↕

c. Press  or  to select the
change that you want.
“U>P” = change to Part Set.
“U>S” = change to Full Set.
“S>U” = change to Unset
“P>U” = change to Unset
↕

d. Press  or  to show any other
↕
