Eaton i-onEX Series - Page 48

4. Administration i-on40 & i-onEX Range
Page 42
the first in a list of the users already
programmed into the control unit. In
the example shown the name is
“User 001”.
8. Press  or  to display the user
you wish to edit.
(Alternatively, if you already know
their user number, you can key that
in and the display will show that
user immediately.)


9. Press  .
The bottom line shows:


10. Press  .


11. Press .
The bottom line of the display shows the
current user type. See page 9 for a
description of the user types available. A
“*” at the beginning of the line is there to
remind you of the current type if you scroll
away.


12. Press  or  to scroll through the
list of user types available.


13. Press  to assign the user type to
the user.
The keypad gives a double “beep”
confirmation tone.


Partitions
(If your system is a part setting system then you will not see this option)
Use this option to assign users to one or more partitions.
Note: You cannot change User 001’s partitions. User 001 always belongs
to all partitions.
1. Make sure the display shows the
standby screen.

